BRAKING EPTA BATFLY Oversize Brake Disc Kit (Front)

The grooves on EPTA BATFLY disk’s surfaces create a self ventilating mechanism allowing the rotor to cool down and self clean

The inner and outer part of this disc are connected with new EPTA technology

 Ø270mm

Kit with:

• Brake Disc
• Pads (772CM46)
• Bracket

Check here the compatibility with your motorcycle

BRAKING Rear Brake Disk for YAMAHA YZ125 02-18 / YZ250 02-21 / YZ-F 250 02-18 / YZ-F 450 03-17

W-FLO discs are built with 6 floating points, the outer part is wavy for better heat dissipation, weight reduction and more braking power

Available in Ø270mm

Kit with:

• Brake Disc
• Pads (772CM44)
• Bracket

Check here the compatibility with your motorcycle

STANDARD VFORCE REED VALVE FEATURES 

• Double the reed tip surface over a conventional reed valve design

• Increased bottom end, stronger mid-range and longer top-end

• Greater efficiency due to reduced reed petal travel

• Reduced reed petal wear

• Screw free design eliminates risk of screws going through motor enables rapid reed petal changes

STANDARD VFORCE REED VALVE FEATURES 

• Double the reed tip surface over a conventional reed valve design

• Increased bottom end, stronger mid-range and longer top-end

• Greater efficiency due to reduced reed petal travel

• Reduced reed petal wear

• Screw free design eliminates risk of screws going through motor enables rapid reed petal changes

VHM Cylinder Head for Yamaha YZ125 05-21 / Fantic XX125 / XE125 2021

• More engine power

• Better heat transference

• More resistance to detonation

• Exchangeable combustion chambers available

Inserts must be ordered seperately

VHM Head Insert (11.20cc) for Yamaha YZ125 05-21 / Fantic XX125 2021

Size: Standard 11.20cc, 0.00, 0.90

• Best overall performance

• Quick to adjust

• Good resistance to detonation

This insert does not fit into an OEM head, only a VHM cylinder head

VHM Piston (Ø53.95) for YZ125 05-24 / Fantic XX125 2021

• High performance
• Inside coating and special Z-clips
• Longevity
• Keeps high performance during lifetime

This piston needs a clearance of 0.05mm! Must be used in combination with a +3mm longer conrod and 20mm small end bearing.